Been thinking about cutting up a HP D60 and make it passenger side drop. Running leafs too.
Couldn't I cut out the long side and then cut it down to the length I need for the short side? I know I would have to move the center section a little to make room for the spring perch to be welded next to the housing. I'm already soa and outboarded for a Chevy axle. I want the HP and don't want to swap to an atlas. Have a clocked d300 now.
As for the long side I was thinking DOM and machine down the ends and reuse the inner C and factory outers. I would have to have custom inner shafts made but want to keep the outers factory length.
PS- I got the axle for free
Ryan.
Sent from my iPhone using Tapatalk
Couldn't I cut out the long side and then cut it down to the length I need for the short side? I know I would have to move the center section a little to make room for the spring perch to be welded next to the housing. I'm already soa and outboarded for a Chevy axle. I want the HP and don't want to swap to an atlas. Have a clocked d300 now.
As for the long side I was thinking DOM and machine down the ends and reuse the inner C and factory outers. I would have to have custom inner shafts made but want to keep the outers factory length.
PS- I got the axle for free
Ryan.
Sent from my iPhone using Tapatalk
Comment